Hi guy's
Each time it too bad weather to sail I tried to finalize te setup of navigatrix.
The last thing is to succeed to get NMEA stream from my multiplexer.
The following configuration was used to work under windows ...
EM-Track connected through serial for GPS position and AIS. This one is working fine
Multiplexer (http://www.gadgetpool.de/nuke/downloads ... rEn1_8.pdf) is connected through USB. That's where my problem begins ... Up to now I didn't succeed to receive stream in openCPN. With Terminal, I didn't succeed to check if there is stream.
pegase@pegase-desktop:~$ lsusb
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 002: ID 0c45:7000 Microdia
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 003 Device 002: ID 0403:6001 Future Technology Devices International, Ltd FT232 USB-Serial (UART) IC
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
pegase@pegase-desktop:~$ dmesg | grep tty
[ 0.000000] console [tty0] enabled
[ 1.531659] 00:08: ttyS0 at I/O 0x3f8 (irq = 4, base_baud = 115200) is a 16550A
[ 1.552308] 00:09: ttyS1 at I/O 0x2f8 (irq = 3, base_baud = 115200) is a 16550A
[ 266.595324] usb 3-2: FTDI USB Serial Device converter now attached to ttyUSB0
[ 267.757421] pps pps0: source "/dev/ttyUSB0" added
pegase@pegase-desktop:~$
ttyUSB0 is member of dialout. I checked this with this command
ls -l /dev/ttyUSB0, that returns crw-rw---T 1 root dialout 188
Then I try to display the stream in Terminal with
cat /dev/ttyUSB0
But I get the message : device or drive busy.
For Opencpn config I attached printscreen.
And now
What can I do to go further ? What can be done ?
Many thanks in advance.
| Attachments: |
|
2016-02-12_203415_1024x768.png [ 183.05 KiB | Viewed 24409 times ] |
|
2016-02-12_202855_1024x768.png [ 121.01 KiB | Viewed 24409 times ] |
